Setup:
1. Bait the Device
-- Open the rear door of the unit.
-- Apply bait on the inside of the door panel.
-- Close the door securely.
2. Position the Trap
-- Place the trap with the solar panel exposed to light for recharging battery.
-- Ensure the critter entrance is positioned to prevent water from entering.
-- Locate trap away from any spark hazards fuel.
3. Power On the Device
-- Locate the ON/OFF - switch ON.
4. Check the LED lights:
-- Flashing LEDs indicate the device is powered.
-- If no LEDs appear, charge with solar panel 8 hrs.
-- The trap is equipped with a rechargeable lithium battery, and all necessary chargers, solar panels, and batteries are included.
5. Ready for Action
-- Once set, the trap will automatically activate. A flashing GREEN LED indicates the trap is ready to "Kick the Critters."
1. Bait the Device
-- Open the rear door of the unit.
-- Apply bait on the inside of the door panel.
-- Close the door securely.
2. Position the Trap
-- Place the trap with the solar panel exposed to light for recharging battery.
-- Ensure the critter entrance is positioned to prevent water from entering.
-- Locate trap away from any spark hazards fuel.
3. Power On the Device
-- Locate the ON/OFF - switch ON.
4. Check the LED lights:
-- Flashing LEDs indicate the device is powered.
-- If no LEDs appear, charge with solar panel 8 hrs.
-- The trap is equipped with a rechargeable lithium battery, and all necessary chargers, solar panels, and batteries are included.
5. Ready for Action
-- Once set, the trap will automatically activate. A flashing GREEN LED indicates the trap is ready to "Kick the Critters."
Operation:
1. Prepare the Device
-- Ensure the trap is baited and powered on.
2. Critter Entry
-- Rodents enter the trap through the front hole.
3. Extermination
-- The critter triggers the internal zapper exterminating the critter before it reaches the bait. This preserves the bait for multiple uses.
4. Rodent Removal
-- The trap automatically ejects the rodent through the front opening.
5. Automatic Reset
-- The trap resets itself after each use.
-- Replace the bait every 60 days to maintain a fresh, attractive scent.
6. LED Indicator Guide
-- Green (Flashing): Trap is ready to use.
-- Red (Flashing): Battery is charging via the solar panel.
-- Red (Solid): Low battery; recharge required.
-- Green&Red (Flashing): = Number of critters exterminated.
1. Prepare the Device
-- Ensure the trap is baited and powered on.
2. Critter Entry
-- Rodents enter the trap through the front hole.
3. Extermination
-- The critter triggers the internal zapper exterminating the critter before it reaches the bait. This preserves the bait for multiple uses.
4. Rodent Removal
-- The trap automatically ejects the rodent through the front opening.
5. Automatic Reset
-- The trap resets itself after each use.
-- Replace the bait every 60 days to maintain a fresh, attractive scent.
6. LED Indicator Guide
-- Green (Flashing): Trap is ready to use.
-- Red (Flashing): Battery is charging via the solar panel.
-- Red (Solid): Low battery; recharge required.
-- Green&Red (Flashing): = Number of critters exterminated.